Hey Team,
I have a SolidRun ClearFog CN9130 hardware.
I am trying to run openwrt on the hardware; however, I have some roadblocks.
When the Openwrt OS is booting I see the WAN port is not detected and throwing error.
Logs
95.624907] mvpp2 f2000000.ethernet eth0: configuring for inband/10gbase-r link mode
[ 95.633534] br-lan: port 1(eth0) entered blocking state
[ 95.638828] br-lan: port 1(eth0) entered disabled state
[ 95.644095] mvpp2 f2000000.ethernet eth0: entered allmulticast mode
[ 95.650599] mvpp2 f2000000.ethernet eth0: entered promiscuous mode
[ 95.663453] mvpp2 f2000000.ethernet eth1: configuring for fixed/sgmii link mode
[ 95.671372] mvpp2 f2000000.ethernet eth1: Link is Up - 1Gbps/Full - flow control off
[ 95.679304] br-lan: port 2(eth1) entered blocking state
[ 95.684559] br-lan: port 2(eth1) entered disabled state
[ 95.689856] mvpp2 f2000000.ethernet eth1: entered allmulticast mode
[ 95.696396] mvpp2 f2000000.ethernet eth1: entered promiscuous mode
[ 95.702706] br-lan: port 2(eth1) entered blocking state
[ 95.707984] br-lan: port 2(eth1) entered forwarding state
[ 95.716403] mvpp2 f2000000.ethernet eth2: validation of rgmii-id with support 00,00000000,00000000,00006280 and advertisement 00,00000000,00000000,00006280 failed: -EINVAL
[ 95.731924] mvpp2 f2000000.ethernet eth2: could not attach PHY (-22)
It will be helpful if there’s any direction.