Solidsense N8 compact no CAN interface

1

Hello,

I am using the Solidsense N8 compact with the default image:

image
image988×886 30.3 KB

I cannot follow this guide as I do not have can0 interface: SolidSense N8 Compact RS485 and CAN bus

if I type “ifconfig -a” I can only see eth0, wlan0, lo interfaces.

By default I do not have loaded the CAN kernel modules, However if I do it manually using modprobe:

  • modprobe can-raw
  • modprobe can-gw
  • modprobe can-bcm
  • modprobe can
  • modprobe can-dev
  • modprobe flexcan

How can I bring it up?

Regards