Hi everyone,
I am having some trouble getting the Wi-Fi up and running on my ClearFog Baseboard:, and I could really use some help. I have been following the setup guide:, but I am stuck at the point where the board should be connecting to my home Wi-Fi network.
Here’s what I have done so far ::-
Installed the latest firmware and OS image.
Configured the network settings via the terminal.
Verified that the Wi-Fi module is recognized by the system.
Despite all this, I can’t seem to get a stable connection. Sometimes it connects for a few seconds:, but then drops. Other devices on the same network are working fine, so I am pretty sure the router isn’t the issue.
Has anyone else experienced similar problems: ?? Could it be a driver issue or something related to the configuration: ?? I am open to any suggestions or troubleshooting steps you might recommend. I also went through this https://www.solid-run.com/embedded-networking/marvell-armada-family/clearfog/rpa/ but couldn’t get anything.
I would really appreciate your help in getting this resolved…! 
Thanks in advance…! 
Marcos Andrew