MPLS HXS configuration in Parse Profile

NXP LX2160
1

I tested MPLS on LX2160A over DPAA2.

Information from Low-Level Hardware Reference Manual: “If MPLS is to be used either DNP(Default Next Parse) or LIE (Label Interpretation) must be configured”.

If DNP is not set, then MPLS packets with labels value > 15 are filtered by dpni interface.

How to configure DNP (for example, DNP=IP (IPv4, IPv6)) and LIE values in MPLS HXS Configuration in Parse Profile?

2

This is not something we have specific knowledge about. Have you looked at the DPAA2 Users Manual. Otherwise it would be best to reach out to NXP. If you have problems getting an answer from NXP let us know and we will gladly reach out to them directly.