CN9130 to Phyreset configuration

Hi all

i am using the 2 dual port Ethernet Phy so how do i configure with the J1 Connector(CN9130) of 27pin(PHY0_RST_N_1.8V) with 2 phy’s

thank you

PHY0_RST_N_1.8V is connected to the 1Gbe PHY that is on the SOM. I assume that the phy you are using is on your carrier. If that is the case then you would need to use other pins assigned as GPIOs to connect to your PHY’s reset signals and then make the appropriate device-tree changes.