how do I set the address of dpmac.1? Even if I use 17 entries in tlv_eeprom: Base MAC Address 0x24 6 FA:00:E7:00:00:00 MAC Addresses 0x2A 2 17 I don’t see any u-boot configuration of dpmac1: Net: eth0: DPMAC3@xgmii, eth1: DPMAC4@xgmii, eth2: DPMAC5@xgmii, eth3: DPMAC6@xgmii, et…

Yes, this will need to be adjusted for different networking configurations.

it seems u-boot/arch/arm/dts/fsl-lx2160a-cex7-8-x-x.dts sets only dpmac3 - dpmac10 and dpmac17: &dpmac3 { status = “okay”; phy-connection-type = “xgmii”; }; &dpmac4 { status = “okay”; phy-connection-type = “xgmii”; }; &dpmac5 { status = “okay”; phy-connection-type = “xgmii”; }; &dpmac6 …

just add something like the below? &dpmac1 { status = “okay”; phy-connection-type = “xgmii”; };

and remove the interfaces that it will replace. These can be referenced in the LX2610a reference manual in the SERDES configuration section.

U-boot doesn't set dpmac.1?

NXP LX2160

joema August 7, 2023, 5:13am 6

thanks!

Topic		Replies	Views
Kernel does not see mac address set by u-boot NXP LX2160	6	495	August 3, 2023
Eth1 gets random mac address NXP LX2160	0	60	July 8, 2024
Change DPMAC17@rgmii-id PHY_ADDR from 0x1 to 0x5 failed in u-boot	2	220	August 2, 2023
How I make NIC config and DHCP presistent? NXP LX2160	8	107	July 6, 2024
U-boot MAC mismatch NXP LX2160	5	759	July 26, 2022

U-boot doesn't set dpmac.1?

Related topics