# Problem with Debian Bullseye installation from built image **URL:** \ **Category:** NXP LX2160\ **Created:** [September 29, 2022, 2:40pm UTC](https://community.solid-run.com/t/problem-with-debian-bullseye-installation-from-built-image/475 "2022-09-29T14:40:37Z")\ **Posts on this page:** 2\ **Page:** 1
**Author:** ![jmazel](https://avatars.discourse-cdn.com/v4/letter/j/2acd7d/32.png) [@jmazel](https://community.solid-run.com/u/jmazel)\ **Post date:** [September 29, 2022, 2:40pm UTC](https://community.solid-run.com/t/problem-with-debian-bullseye-installation-from-built-image/475/1 "2022-09-29T14:40:37Z")
Hello I used the [GitHub - SolidRun/lx2160a\_build: Scripts to build basic images for LX2160A COM express type 7 modules](https://github.com/SolidRun/lx2160a_build) repo to build a Debian-based image. I replaced ${DISTRO:=ubuntu} by ${DISTRO:=debian} and built the image using the docker commands. I then flashed the img on a SD card. After booting on the SD card (cf bootswitch configuration), when I type “load mmc 0:1 0xa4000000 debian-bullseye.img” in the prompt, I get the following error after a small delay: mmc fail to send stop cmd \*\* fs\_devread read error - block Failed to load ‘debian-bullseye.img’ How can I fix this? This command (and the next two) are working when I put an Ubuntu img file on the SD card. Thank you for your time. Best regards, Johan ---
**Author:** ![jmazel](https://avatars.discourse-cdn.com/v4/letter/j/2acd7d/32.png) [@jmazel](https://community.solid-run.com/u/jmazel)\ **Post date:** [October 3, 2022, 9:23am UTC](https://community.solid-run.com/t/problem-with-debian-bullseye-installation-from-built-image/475/2 "2022-10-03T09:23:01Z")
I wrote the same image on the SD card again and the error disappeared. I guess I had a writing error when I wrote the image the first time. Is there any clean way to mark this problem as solved?