# How to boot from Yocto prebuilt Image? **URL:** \ **Category:** NXP i.MX8M Plus\ **Created:** [July 29, 2021, 9:07am UTC](https://community.solid-run.com/t/how-to-boot-from-yocto-prebuilt-image/130 "2021-07-29T09:07:21Z")\ **Posts on this page:** 2\ **Page:** 1
**Author:** ![SLamda](https://avatars.discourse-cdn.com/v4/letter/s/ea666f/32.png) [@SLamda](https://community.solid-run.com/u/SLamda)\ **Post date:** [July 29, 2021, 9:07am UTC](https://community.solid-run.com/t/how-to-boot-from-yocto-prebuilt-image/130/1 "2021-07-29T09:07:21Z")
Could you tell me the way to boot from yocto prebuilt image? I wrote the image which downloaded from solid run Images([SolidRun Images](https://images.solid-run.com/IMX8/)), but it cannot boot up and repeat reboot with bellow logs on serial console. SOM:i.MX8M Plus Carrier Board: HummingBoard Mate Image:imx-image-full-imx8mpsolidrun.wic.bz2 ( imx8mp\_yocto\_gategarth-5.10.9-1.1.0/ 1.16GB 05/May/2021 04:49:09) ------Log------ U-Boot SPL 2020.04-5.10.9-1.0.0+gf0120c90dc (Mar 05 2021 - 07:05:56 +0000) Training for 3GByte Micron DDRINFO: start DRAM init DDRINFO: DRAM rate 3000MTS Training FAILED Re-training for 1GByte Samsung memory DDRINFO: start DRAM init DDRINFO: DRAM rate 4000MTS DDRINFO:ddrphy calibration done DDRINFO: ddrmix config done Normal Boot Trying to boot from BOOTROM image offset 0x8000, pagesize 0x200, ivt offset 0x0 ---
**Author:** ![SLamda](https://avatars.discourse-cdn.com/v4/letter/s/ea666f/32.png) [@SLamda](https://community.solid-run.com/u/SLamda)\ **Post date:** [August 2, 2021, 10:29am UTC](https://community.solid-run.com/t/how-to-boot-from-yocto-prebuilt-image/130/2 "2021-08-02T10:29:57Z")
I had a mistake when burn the boot image to SD card. I used " balenaEtcher" to write compressed image without uncompression. I have written the boot image after uncompession and confiremed it work well. It seems that " balenaEtcher" does not support bz2 comppressed image.