# Boot Select & RESET Button **URL:** \ **Category:** NXP LX2160\ **Tags:** NXP-LX2160\ **Created:** [April 22, 2021, 11:23am UTC](https://community.solid-run.com/t/boot-select-reset-button/30 "2021-04-22T11:23:03Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![AmeliaHarwood](https://avatars.discourse-cdn.com/v4/letter/a/7c8e57/32.png) [@AmeliaHarwood](https://community.solid-run.com/u/AmeliaHarwood)\ **Post date:** [April 22, 2021, 11:23am UTC](https://community.solid-run.com/t/boot-select-reset-button/30/1 "2021-04-22T11:23:03Z")
Hi, How can I configure the boot switch of the HoneyComb to boot from eMMC/SD card? Which button is RESET and which one is POWER? how can power on/off the board? ---
**Author:** ![YazanShhadySR](https://avatars.discourse-cdn.com/v4/letter/y/a6a055/32.png) [@YazanShhadySR](https://community.solid-run.com/u/YazanShhadySR)\ **Post date:** [April 22, 2021, 12:16pm UTC](https://community.solid-run.com/t/boot-select-reset-button/30/2 "2021-04-22T12:16:20Z")
Hi Amelia, **Boot Switch (SW1):** Did you have information between the boot switch SW1 and the CPU on the print side (Notice the marking ‘ON’ on the DIP switch)how to boot from SD card, eMMc, SPI. for example to booting from SD-Card: configure the boot switch SW1 to be [1:off,2:on,3:on,4:on,5:nc] **RESET Button:** Did you have two Reset buttons one on the carrier U14, the second one on the COM U2 **Power On/Off Button (U10012):** **Power Off:** need a long press (like 10 sec) to power off the board until the LED1 turns off. **Power ON:** need a short press to power ON the board until the LED1 turns ON. ---
**Author:** ![alex9373](https://avatars.discourse-cdn.com/v4/letter/a/ecc23a/32.png) [@alex9373](https://community.solid-run.com/u/alex9373)\ **Post date:** [December 5, 2021, 11:20pm UTC](https://community.solid-run.com/t/boot-select-reset-button/30/3 "2021-12-05T23:20:16Z")
Specifically eMMC boot is off, on, on, off, nc, right?